Two-position Tool Post (1/4"/1/4"), P/N 3003

It is not unusual to have to stop and change lathe tools several times while turning a part on the lathe. The change may be to switch from a left-hand tool to a right-hand tool, from a sharp-nosed tool to a radius-tipped tool, or from a roughing tool to a finishing tool. Whatever the reason, each change requires a little setup time. This time can be reduced by using a two-position tool post. Each Sherline two-position tool post mounts two 1/4" lathe tools. By having one or more of these tool posts with your favorite lathe tool pre-mounted in them, you can simplify your work and reduce the time required to change tools.

Other special tool posts are also available:

P/N 3008, 2-position tool post, 5/16"/3/8" for larger size lathe tools

P/N 3057, Rocker tool post

P/N 7600, 3/8" Insert holder tool post (3/8" square and round)

RETURN TO ACCESSORIES MASTER LIST

Shop for Sherline LATHES

Shop for Sherline MILLING MACHINES

RETURN TO My Home Page

| Home Page | Frequently Asked Questions | Testimonials | Lathes |
| Mills | Accessories | Tool Prices | Accessory Prices |